Working on 3D project 4 : Part 2

For the next step, I started to make the table. I used mountboard and cut it into square and also the round wooden stick I cut it into the right size that I want. I also use popsicle stick crafts and cvut it into small square as it is for the support of the table. Then, I use hot glue gun and wooden glue to stick them.

This is how the table turned out. I also print out some marble texture on paper and cut it into the size of the top of the table and stuck it in each table so it will give a look of marble table which I use in my design project.

For the chair, I used popsicle stick crafts to make as I have shown in the 3d outcome planning. I use acrylic paint to paint the chair. I also made the booth seating. 

I also used this acrylic to paint some part of the wall.

I also print out some tiles effect on the paper to stick the wall and the floor.

 

Next, I started to stick them all together using both PVA glue and hot glue gun.

For the ceiling I do not know how to make the suspended light so I just use the fairy and stuck them on the ceiling using tape.

This is the final 3d turned out.